 | チェンジャーラック現在、このページはご希望の言語でご利用いただけません。 Google 翻訳を使用すると自動翻訳でページを表示できます。 弊社はこのサービスの提供に責任を持たず、翻訳結果を弊社でチェックすることはありません。
Changer racks
About stylus and probe changingThe range of features and components that must be measured in a typical factory means that manufacturers need a flexible measuring solution. A single sensor and stylus configuration will not be sufficient in most cases. Is it best to change sensors, or should you change styli? Stylus changing
Styli can be changed manually using a threaded connection, but re-calibration is required. Probe systems are now available with a repeatable, automated means to switch styli, reducing manual intervention and eliminating the need to re-calibrate. Probe autochange systems
In other words, one sensor may not be suitable for all your measurement needs. If the range of features and parts that you must measure demands a range of sensors, then a sensor changing system is essential. Sensor changing requires a repeatable, automated joint between the probe head or CMM quill and the probes that you want to use. You will also need to store sensors that are not in use.
MRS modular rack system
Extended warrantyA 3-year warranty is available for your new CMM products during the first 3 months from purchase. Contact your vendor. 
Free Renishaw changer racks and probe modules * Conditions apply. Purchase from participating CMM supplier. Marketing literature
お問い合わせ詳細 や価格についてのお問い合わせは、オンラインでお寄せ下さい。直接コンタクトをご希望の場合は、 現地レニショーオフィスまでご連絡ください。 |
A selection of versatile, protective changer racks and manual storage systems for your CMM, enabling rapid sensor and / or stylus changing.
Unless you are measuring a simple component, you will need to change your stylus configuration to suit different measurement tasks - e.g. accessing deep features that require long or complex styli, as well as using different tips (sphere, disc, cylinder).
A scanning sensor is the most flexible sensor you can fit to your machine, since it can perform discrete point measurement as well as scanning. However, it is not the optimum sensor for more specialised tasks like measurement of soft materials where a non-contact sensor will be best.
Many manufacturers find that they need the flexibility of both stylus changing AND sensor changing. The combination means that you will always be using the right sensor and stylus for each task - increasing your measurement accuracy whilst minimising measurement cycle times.
